anybody converted manual windows to power windows?
Announcement
Collapse
No announcement yet.
power windows
Collapse
X
-
Originally posted by Dixie94Proanybody converted manual windows to power windows?
i imagine if you ripped out the old manual window and installed the power window bracket it would fit with a few new holes then just go to the junkyard and grab all the wiring from the windows of a power protege...
-
Originally posted by TheMANjust go look for an LX to replace your car, everything is bettar!
2000 White Protege LX
Sumitomo 195/60HR14
2 x Polk DB570 (5"x7")
Kenwood KDC-MP522 Head Unit
Kenwood KAC-7251 (800 W) Amp
Audiobahn AWC10T x 2 Subs
Kenwood Music Keg
Black Widow Keyless Entry
Intake- Custom SRI
Clear Corner Lights
APC Clear Tail Lights
Comment
-
i stand corrected, and didnt know that.
2000 White Protege LX
Sumitomo 195/60HR14
2 x Polk DB570 (5"x7")
Kenwood KDC-MP522 Head Unit
Kenwood KAC-7251 (800 W) Amp
Audiobahn AWC10T x 2 Subs
Kenwood Music Keg
Black Widow Keyless Entry
Intake- Custom SRI
Clear Corner Lights
APC Clear Tail Lights
Comment
-
I put power windows in my SE. Well just the driver side. You need everything TheMAN mentioned.The motor bolts into the exact same spot. I didn't have to change any under-dash harness. Although I was never able to get my passenger side power window working. The motor and regulator were good, but either I wasn't getting power to them or the switch was bad. The back windows I never did becasue you have to get the harness out of an LX, that runs under the carpet. I've been to lazy to pull my carpet to do it so....I figure I will probably get around to it when I order a new carpet since mine's fubared.
Comment
-
I pulled the front power windows from my 91 lx and installed them into my 94 dx....personally the only hard part was disconnecting and the wire harness in the door jam, just take a good look at how the motor is mounted in the door before you pull it,
Parts Needed
Door panel
door switches
wire harness from inside the door only (disconnects at door jam)
motor
I swapped these parts only and both my front windoes work great, besure to grease everything up while you have it out.....I didn't have to replace or diconnect anything else....
DaPro94 Protege DX SOHC 1.8l 5 Speed
(DaPro)
its better to wait and save then to waste money on crap to get you by....
Comment
Comment