Ok...all my pulls were around 10psi. Pump Gas 93octane. EMS -> MPI Tunner
Sometimes It would do only 9.5 and sometimes near 11psi
I used the dyno to just do some fine tuning and see the graphics results and to check for ping and knock. And actually...it happened when added some timing @ 3000rpms and up top 6300rpms.
Surprisingly...my tunning was good...a map similar to what Little Beavis did for me on the streets @ 6-7psi. So I added some more fuel, pulled some timing and went up to 10+psi.
At this moment I was very concerned with pinging and detonation and guess what, I was 2 degrees before it starts to get noticed. So now Im pulling 11 degrees off.
Video: http://home.coqui.net/igdrasil/mpi/MPIDyno.wmv
Sometimes It would do only 9.5 and sometimes near 11psi
I used the dyno to just do some fine tuning and see the graphics results and to check for ping and knock. And actually...it happened when added some timing @ 3000rpms and up top 6300rpms.
Surprisingly...my tunning was good...a map similar to what Little Beavis did for me on the streets @ 6-7psi. So I added some more fuel, pulled some timing and went up to 10+psi.
At this moment I was very concerned with pinging and detonation and guess what, I was 2 degrees before it starts to get noticed. So now Im pulling 11 degrees off.
Video: http://home.coqui.net/igdrasil/mpi/MPIDyno.wmv
Comment