Anyone ever do a complete AC system removal?
A snag kinda hit me, the nuts that are welded inside the lower rad support (for the crossmember) busted loose and the only way I can figure to fix it, is to remove the AC components to get access to the top of the support and either cut part of it away to install new nuts or drill out two large holes over each and install that way.
Either way time consuming, but if leaving the AC off, I will remove the compressor as well, but I would need a smaller belt.
Would anyone know what size?
A snag kinda hit me, the nuts that are welded inside the lower rad support (for the crossmember) busted loose and the only way I can figure to fix it, is to remove the AC components to get access to the top of the support and either cut part of it away to install new nuts or drill out two large holes over each and install that way.
Either way time consuming, but if leaving the AC off, I will remove the compressor as well, but I would need a smaller belt.
Would anyone know what size?
Comment