If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have heard someone was making one but it wouldnt put ya that high in displacement. I also seem to remember a particular someone saying a stroker kit was a bad idea given the rod ratio was bad enough as is...
Either way dun think there is much out there in the ways of upped displacement.
there's no way to make a BP into a 2.2L without a HUGE block spacer plate. there isn't a lot of room to goto 2L even. Infact, the old Mazdaspeed kit could only be installed in 1 of every 4 BP blocks, which all had to be X-rayed to see if they had enough meat in them to do the machine work needed.
Comment