If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Originally posted by photoeye0 I finally got my hands on a lx but it is an auto. But my dx is a manual. Is it possible to run my trany with dohc motor if so what comp should I run.
I don't know
Thank you
Rick
lots of people use the engine off of an atx and drop it into their mtx. i have done a swap into a 323 using an eGT atx BP. all you need to do is keep the flywheel off of your existing motor.
dont forget about to alos keep the 3 tranny mount that are in your current car. you will only need the p-side engine mount. You will need to wire in 2 wires, one for the VICS, one for the 4th wire on your disty.
When you turn your car on... does it return the favor?
Originally posted by goldstar
Yes, still have it. It was my attempt to immortalize you in verse.
A Protege driver named Brock
Once said 7 seconds he'd clock.
So his engine he goosed
With much too much boost,
And drove a rod through his block.
Originally posted by Protoss dont forget about to alos keep the 3 tranny mount that are in your current car. you will only need the p-side engine mount. You will need to wire in 2 wires, one for the VICS, one for the 4th wire on your disty.
this I needed to know for my 323 BP swap ... hehe.. thanks.. I was just waiting for someone to post it ...
Bruce
What does the code on your ecu say ...
I have a spare 1st gen ecu but I don't know which model it is for. uhhh actually , I just didn't feal like looking yet.
Comment