Ok so I've been posting a lot on this forum about what I'm doing on my car this is the the post for my project protege 4wd. I will be converting it from a ATX to MTX with a BPT Tranny and a EGT motor. While I've been getting in parts and all that I've been taking some pics and eventually I think I may do a write up but anyway this is what I have so far:
^Shifter from 4wd.
^Brake MC and clutch MC other hard and soft lines.
^Ford bp05 only 50k miles and only $200
^Ford bp05
^ECU out of an EGT
^Harness and ECU pulled from EGT
^The car that it's going into
I think I need motor mounts and maybe some slight bit of wiring later on but can anyone else think of something I else I may need?
^Shifter from 4wd.
^Brake MC and clutch MC other hard and soft lines.
^Ford bp05 only 50k miles and only $200
^Ford bp05
^ECU out of an EGT
^Harness and ECU pulled from EGT
^The car that it's going into
I think I need motor mounts and maybe some slight bit of wiring later on but can anyone else think of something I else I may need?
Comment