As promissed, here is a pic of my unfinished ms harness. I took my old B8 harness and ripped out all the unnecessary crap. To finish, I need to make some order in the grounds and it is done.
The whole harness
6 wire injector plug, disty, fan thermoswitch and shielded O2 wire (in case)
Power from fusebox, igniter and coil plugs
MS end, need to solder the DB37 connector
What's left going to the main harness: fan thermoswitch, fp power, tach, temp sender and a bunch of grounds going from interior to the ground point.
BTW, does anyone know what are the 2 red/green and yellow/white wires that are shorted in the last pic? They had a short connector in the middle of the harness so I just removed and shorted them at the beginning.
The whole harness
6 wire injector plug, disty, fan thermoswitch and shielded O2 wire (in case)
Power from fusebox, igniter and coil plugs
MS end, need to solder the DB37 connector
What's left going to the main harness: fan thermoswitch, fp power, tach, temp sender and a bunch of grounds going from interior to the ground point.
BTW, does anyone know what are the 2 red/green and yellow/white wires that are shorted in the last pic? They had a short connector in the middle of the harness so I just removed and shorted them at the beginning.