Announcement

Collapse
No announcement yet.

Ms2 Msq

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Ms2 Msq

    Hey guys,

    I managed to load the MS2 extra firmware version 2.0.1 and I am able to communicate with the controller. I started setting up parameters yesterday but being it's the first time, I'm not 100% confident.

    Would anyone mind sharing their MSQ file for a NA BP, set up for wasted spark? I have stock injectors, stock engine, CAS (dizzy) and coilpacks. Will be using LC1 for AFs

    I want to wire the MS in the car and make it run well before I slap my 16G on the car and retune for some serious power.

    Any help would be appreciated,

    Thanks

    #2
    matt (the mod in this forum) is the only person running MS2e at the moment i believe. he is NA but he has high comp pistons.
    Escort GTR -- 11.87 @ 117.6 mph -- 320 HP / 325 Ft. Lbs. @ 23 PSI
    ... The first FWD BG with a Toyota E153 transmission conversion in the USA!
    Looking for BP x Toyota E153 adapter plates? PM me or contact me on Facebook: Riel Performance Parts

    Comment


      #3
      Should be similar, just means I can advance the timing even more. i'll wait for Matt to post, thanks

      Comment


        #4
        when I get home from work tonight I'll post up my MSQs. I'll have too root around a bit to find the last non-beta-code files I have though

        I assume you've got the 2nd ignition trigger circuit installed?
        Ask me about engine management!

        Comment


          #5
          Thanks, would be much appreciated. I started yesterday with the basic settings but I'm not sure about all the PWM idle settings for our cars and some fuel parameters.

          i followed the DIYautotune miata write up for the input and output mods. I did build the pull up circuit for the second CAS input like shown. Did I need to build a second opto isolating circuit insteat?

          Comment


            #6
            I would really really REALLY recommend you build the opto-isolated circuit shown on the MS2/Extra docs, here: http://www.msextra.com/ms2extra/MS2-Extra_4_1.htm

            Make sure both triggers are set up the way they're shown in the docs.
            Ask me about engine management!

            Comment


              #7
              Damn, I wasn't sure that the 2nd circuit was needed so I built it and then removed it from the board as it wasn't part of the Miata How to. I'll build it again then.

              Do I absolutely need to modify the main (4 slot) circuit or can I leave it as is? I don't quiet understand why is the ciruit upside down and the signal comes from the non conducting side (XG1) of the opto isolator instead of OptoIn?

              Did you have time to fetch the MSQ file from your MS2? just reminding if it isn't too much to ask. BTW, I loaded the 2.0.1 code on mine.

              Thanks for your help

              BTW, if you prefer, you could just send it to me by email to l3shka@hotmail.com
              Last edited by 323driver; 08-12-2008, 08:38 PM.

              Comment


                #8
                sorry, I didn't get home till a couple hours ago and had to chill out for a bit.

                I dropped you an e-mail.
                Ask me about engine management!

                Comment


                  #9
                  No problem man, I was trashed as well, not enough sleep lately... emailed you.

                  Comment

                  Working...
                  X