Jim (JPmotorsports) has been kind enough to design, and produce a 4-point front lower tie bar for us. This design will stiffen the front subframe significantly more than a 2-point design. The price will be $185 + shipping and Tax. There is also the option to add a gusset at each corner for $20 extra. The first payment will be $100 and will be due when we have 5 people signed up. It will be payed directly to Jim. The final payment will be roughly $125 to $150 depending on your shipping cost, plus $20 extra if you want gussets.
Here is a photo.
And here are the specs
It will use 1 1/4" cups to bolt to the front control arm bolts and 1 1/4" cups that use the subframe bolt in back next to the rear control arm mounts. We'll use 1" x .120 wall DOM tubing in between the cups.
It has a 1/4" clearance at the trans crossmember and I'm going to need some help with measurements in the rear to clear a stock exhaust system---I don't currently have a car with a stock exhaust so we'll have to work it out with photo's and measurements.
EDIT:We have the clearance issues worked out!!!
We are looking to get at least 5 people signed up before production begins, but there will be no real limit to how many are made, as long as you are interested they will be produced.
PM me or reply to this thread. I will put you on the list, and will then get you the info when it's time to pay Jim and I will gather your shipping info for him.
The list goes as follows...
1:300ZXRB26DETT (1st payment in)
2:AtomicEGT
3:Woodsish (1st payment in)
4:AJAX
5:Honda Killer
...
10:Cody004
...
All right, for the first five on the list... First payment is due. You should either have or be getting soon, a PM with Jim's paypal and a bit more info, from me.
Everyone else, keep signing up as we can make these as long as there is interest in them!
Here is a photo.
And here are the specs
It will use 1 1/4" cups to bolt to the front control arm bolts and 1 1/4" cups that use the subframe bolt in back next to the rear control arm mounts. We'll use 1" x .120 wall DOM tubing in between the cups.
It has a 1/4" clearance at the trans crossmember and I'm going to need some help with measurements in the rear to clear a stock exhaust system---I don't currently have a car with a stock exhaust so we'll have to work it out with photo's and measurements.
EDIT:We have the clearance issues worked out!!!
We are looking to get at least 5 people signed up before production begins, but there will be no real limit to how many are made, as long as you are interested they will be produced.
PM me or reply to this thread. I will put you on the list, and will then get you the info when it's time to pay Jim and I will gather your shipping info for him.
The list goes as follows...
1:300ZXRB26DETT (1st payment in)
2:AtomicEGT
3:Woodsish (1st payment in)
4:AJAX
5:Honda Killer
...
10:Cody004
...
All right, for the first five on the list... First payment is due. You should either have or be getting soon, a PM with Jim's paypal and a bit more info, from me.
Everyone else, keep signing up as we can make these as long as there is interest in them!
Comment