About 2 years ago I found the GTR front clip while looking for a b6t for
my 86 323 dx. Of course there was no way I was going to past on
getting my hands on all that bpd goodness. So the better part of 2
years later I've almost got her done and want to get a thread started.
I just can't wait!
All that is really left is getting the intercooler piping and exhaust done.
After that it's a matter of itergrating the body wiring of the 86 323 into
the engine wiring of the GTR.
Now pics! :D
This is her before anything has been done with stock b6 and f-type transaxle.
Engine, stock exhaust, and transaxle removed. The stock wiring was removed soon after this picture was taken.
Just getting the front clip home.
I striped down the clip and removed the bpd and four wheel drive transaxle
Four wheel drive transaxle removed
New flywheel and Centerforce Dual Friction Clutch installed on bpd and g-type transaxle before rebuild.
Lowering the engine in so we can figure out how the fabricated mount on the
passenger side needs to be made. Also the g-type has been rebuild and painted.
Tight fit...
I've got the fabricated mount in there now also in the middle of moving the radiator to the
passenger side from the driver side to make the intercooler piping easier to make.
More pictures when I get out and take them the next few days. :D
my 86 323 dx. Of course there was no way I was going to past on
getting my hands on all that bpd goodness. So the better part of 2
years later I've almost got her done and want to get a thread started.
I just can't wait!
All that is really left is getting the intercooler piping and exhaust done.
After that it's a matter of itergrating the body wiring of the 86 323 into
the engine wiring of the GTR.
Now pics! :D
This is her before anything has been done with stock b6 and f-type transaxle.
Engine, stock exhaust, and transaxle removed. The stock wiring was removed soon after this picture was taken.
Just getting the front clip home.
I striped down the clip and removed the bpd and four wheel drive transaxle
Four wheel drive transaxle removed
New flywheel and Centerforce Dual Friction Clutch installed on bpd and g-type transaxle before rebuild.
Lowering the engine in so we can figure out how the fabricated mount on the
passenger side needs to be made. Also the g-type has been rebuild and painted.
Tight fit...
I've got the fabricated mount in there now also in the middle of moving the radiator to the
passenger side from the driver side to make the intercooler piping easier to make.
More pictures when I get out and take them the next few days. :D
Comment