If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
I have a spare set of injectors from a 4G63-T Talon and was wondering if they would work in my GTX. They are grey top and I don't know if it would even be an upgrade over stock. Has anyone done a mod like this?
Thanks
adam
I have a spare set of injectors from a 4G63-T Talon and was wondering if they would work in my GTX. They are grey top and I don't know if it would even be an upgrade over stock.
The 4G63-T injectors are low-impedance 440cc. Your ECU demands high-impedance. Adding resistors will reduce current draw and make these injectors usable. However, they'll also slow the injector's response significantly. Thus, it's not an optimal solution.
Within weeks I'll have a range of drop-in injector solutions for the B6T. Flow rates will likely be 415, 430, 550, and 630cc at 3bar. Spray patterns will be optimized for B6 head geometry.
Scott F. Williams
Team Director
Usually Sideways Rally Team www.usrallyteam.com
856.456.3335
We've got the 630cc figured out about 95%. Spray pattern is a wide angle cone with very fine atomization. Standalone engine management controls idle perfectly. With a 3bar fpr and pump fuel, max horsepower that they'll support should be about 400bhp.
Scott F. Williams
Team Director
Usually Sideways Rally Team www.usrallyteam.com
856.456.3335
Comment