I'm in the process of doing a GTR BPT engine swap in my 1993 SOHC MX3. I removed the stock ecu and engine harness and when i went to install the GTR harness i noticed one of the connector was different. Located down by the ECU, there is a black and white connector. On the MX3 the white connector is a 10 pin connector and there is another seperate two wire connector. Whereas the GTR has one single 15 pin connector.
The Black connectors are the same but have different wires in different locations? and not too sure what to do about the White connectors? Here's some pictures
MX3 White 10 pin connector Plug ^
MX3 White 2 pin connector plug ^
GTR White 15 pin connector Plug^
MX3 Engine Harness ^
GTR Engine Harness (X-06 is the 15 pin white plug and X-03 is the black plug) ^
The Black connectors are the same but have different wires in different locations? and not too sure what to do about the White connectors? Here's some pictures
MX3 White 10 pin connector Plug ^
MX3 White 2 pin connector plug ^
GTR White 15 pin connector Plug^
MX3 Engine Harness ^
GTR Engine Harness (X-06 is the 15 pin white plug and X-03 is the black plug) ^
Comment