Announcement

Collapse
No announcement yet.

Crank pulley clearance to chassis? help

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    Crank pulley clearance to chassis? help

    Yep, i made a brainfart!

    pulled my engine up to do some mods. Among those a megasquirt install. im going to install a crank trigger tooth wheel on the pully. this wheel will decrease the space about 8 mm to the chassis. This that ok? how much space do i have with the B6T engine?

    help is much appreciated...

    #2
    You should have enough. If not, then break out the big-assed-hammer.

    Comment


      #3
      How sure are You?

      Comment


        #4
        Sure enough to tell you that you might have enough clearance.

        Sure enough to tell you that a big mallet will persuade the rail to make the room, if there isn't.

        Comment


          #5
          Where, exactly, are you mounting the trigger wheel?

          Comment

          Working...
          X