Does anyone or has anyone assembled a B6T personally ?
My block, crank and head are at the machine shop currently and should be back in a week or so. My block is getting Honed and hot tanked, my crank is being mic'd and checked. And my head is getting a valve job.
I'm planning on running King bearings and sealed power rings.
I was planning on assembling the motor myself and wanted to know if anyone had a spec sheet of some sort about clearances.
My block, crank and head are at the machine shop currently and should be back in a week or so. My block is getting Honed and hot tanked, my crank is being mic'd and checked. And my head is getting a valve job.
I'm planning on running King bearings and sealed power rings.
I was planning on assembling the motor myself and wanted to know if anyone had a spec sheet of some sort about clearances.
Comment