Announcement

Collapse
No announcement yet.

JDM ITR wheels

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    JDM ITR wheels

    I am looking at getting a set of JDM ITR wheels for my GTX, has anybody ever tried these? Will Honda wheels fit? They are the same bolt pattern, the early JDM ITR had the same 4x114.3 bolt pattern, I'm not sure if the hubs would have clearance issues or anything.

    #2
    Unless I'm forgetting a generation all ITR's were five lug.


    '88 323 sedan, K-swapped..

    '03.5 Mazdaspeed Protege - miss it so much..

    '01 Dodge Ram 3500 Cummins - 323 hauler

    Comment


      #3
      All the ones sold here were yes, but not the JDM ones. We didn't get the ITR until 97, and they had it a couple years before we did.

      Comment


        #4
        I'm 99% certain I've seen a pic of them on a GTX. I know I was considering them for a while. I'm not sure what the hub bore is though.
        sigpic
        1992 Familia GT-X
        1988 323 GTX
        2011 F150 Lariat Ecoboost
        2014 Civic Touring

        Comment


          #5
          They should fit fine. The hub bore is the same as most other 4x114.4mm Hondas which is 64.1mm (waaay bigger than the GTX - ok, not way bigger - 59.6mm). The hard part might be finding hub-centeric sizing rings if that is important to you (not critical). I have run Hyundai Tiburon (67.1mm) rims on my GTX with no problems, but they were no where near as light as the ITR rims.
          Last edited by J.P.; 09-01-2011, 07:39 PM.
          1988 323 GTX
          2009 Mazda 5

          Comment


            #6
            they are 50 offset so youll be 18mm closer to the strut but should still have room bout 1/2 inch from strut to tire if i remember right. i was gonna pick up a set but decided to hold off for a bit

            Comment


              #7
              I think they'd look nice...always wished they had a set of 15-16" in 4x100 in that style...nice light looking sport rim to me.
              -Jack

              ONTARIO MAZDA CLUB! Join! https://www.facebook.com/groups/500055016671733/

              91 626 LX - basically stock and pretty slow still
              http://www.clubprotege.com/forum/sho...my-GD-626-LX-)

              01 E53 3.0i - FOR SALE! pm if interested

              91 USDM Protege LX - SOLD! turbo/manifold up for sale!
              http://www.clubprotege.com/forum/showthread.php?t=46606

              Comment


                #8
                i believe you can get a replica made in 4x100 if i remeber right i think it cost right around 700 or so a few years back

                Comment

                Working...
                X