hoooookayy, when I was draining the trans fluid to refill it tonight after replacing the left axle, I grabbed the yoke of the lobro joint on the driveshaft, where it comes out of the trans, and yanked on it. There seems to be the tiniest bit of play there, probably less than a mm, but enough to feel that there is a slight movement there.
What're the odds that I need to replace the output shaft bearing and seal, etc? Never had to deal with this exact part before, but I'd rather nip it in the bud now.
--sarge
What're the odds that I need to replace the output shaft bearing and seal, etc? Never had to deal with this exact part before, but I'd rather nip it in the bud now.
--sarge
Comment