Announcement
Collapse
No announcement yet.
kertap's daily driver
Collapse
X
-
mods done to the car as of now
6 puck clutch
new axles
new timing belt,radiator,water pump
plug,wires,cap,rotor
98 injectors
shift light,digital tach(just looks like a shift light)
steering wheel
hid kit high and low(not installed yet)
has 178xxx miles on it
fixing to put the 1.8l calipers on the front so i can run my 1.8l drilled and slotted rotors will post pics of that install as soon as i get the money to buy the rotorsLast edited by kertap; 05-26-2012, 06:03 PM.
-
Hey i got a quick question i just installed my hids and it randown flickers on the passenger side all conections are good and no cuts it mostly dors it random or wen i hit a hard bump any suggestions this is the second kit i have put in thinking it was tje kit this last kit i bought was 70 bucks and the first one was 30
Comment
-
It should, yes. I think the '95/'96 mounted differently than the '97/'98 bar, but the bar itself is the same. I'd have to look at my Haynes manual again to make sure.
As for the HID cutting out, are your grounds good? My passenger light flickers when it gets wet sometimes because the ground is pretty exposed.
Comment
Comment