I'm installing an Auto meter tach on the dash of my car and I need to know where the coil or the tach terminal on the electronic ignition is. I don't have a Haynes manual to look at so any help would be appreciated. If you have a picture, that would be even better. Thanks.
Announcement
Collapse
No announcement yet.
Tach install Help Please
Collapse
X
-
The tach has 4 wires: +12 Volts, Gnd, Lights and the tach drive wire. The tach drive wire is connected to the violet/white wire coming out of the diagnostic port which is located on the left side of the engine bay near the ground plate for the batt. negative cable.....HELLO MY NAME IS BEN...
186.08whp
225.94wtq
torque monster!!!!
dyno graph 8-10-and 12psi
http://www.msprotege.com/members/THE...no%20graph.jpg
http://videos.streetfire.net/player....0-C19CA06AF01E dyno vid
blahblahblahblahblahblah
Comment
-
i had the same problem i think some of the fuses blew when i connected the battery back up i think i did some thing wrong but i'll have to try againg tommarrow because it started to rain03 SILVER DX: 30% IN FRONT AND 20% TINT IN BACK, 600W SONY XPLOD AMP, 2 10'' SUBS, 3 3/8'' TACH W/SHIFT LIGHT
check it out at
members.cardomain.com/phoenixzero
Comment
Comment