I was just going to mount my harnesses to where my rear seat belts bolt in, but I have a roll cage so I was thinking about looping them around the cage. The thing is the only bar I can mount onto is not straighty horizontal. its almost at a 30% angle so I don't know if that is would effect anything. I know It might slide down but I could make a bracket for them to stay where I want them to.
Another issue is I don't have much up front room in my car because of the roll cage being so far up. So my seat would literally be right against the cage that im mount the harness to. Any issue there?
Thanks
Another issue is I don't have much up front room in my car because of the roll cage being so far up. So my seat would literally be right against the cage that im mount the harness to. Any issue there?
Thanks
Comment