Announcement

Collapse
No announcement yet.

which cat?

Collapse
X
Collapse
 
  • Page of 1
  • Filter
  • Time
  • Show
Clear All
new posts
Previous template Next
    #1

    which cat?

    so i'm doing the 1.8l swap and i'm putting in 2.25" custom mandrel bent tubing along with high flow cat. which cat should i buy?
    1) http://cgi.ebay.com/ebaymotors/ws/eB...spagename=WDVW
    and weld o2 bosses into the piping?

    2) http://cgi.ebay.com/ebaymotors/ws/eB...spagename=WDVW
    or would this setup suffice? and prevent a CEL from popping up?

    thanks for any input guys.
    Almost there

    jdm tails... check
    jdm bumper... check
    ms lip... check
    ms grill... check
    ms sideskirts... check
    ms rear skirts... check
    ms spoiler... check
    ms struts... check

    Still trying for a bp swap..:
    Fidanzda 8lb flywheel, ACT HD00, UR Crank Pulley, UR Adj. Cam-Gears, Exh-Intake CamShaft Swap, MS Engine Mounts, Custom CAI, PaceSetter Header, 2.25" in/out-let Magnaflow Cat, 2.25" Mandrel-Bent Exhaust.
    Tags: None
    #2
    I am not too sure for 1.8L enigine, but 1.5 does not have any sensors on the 2nd cat. The two sensors that are there, are located right before and after the first cat. So I think you can go ahead with choice 1).
    "Probable impossibilities are to be preferred to improbable possibilities."

    Comment

      #3
      Hey, where did you get the exhaust from? EssentialSpeed? I'm just wondering
      Don't have a car anymore... cry with me

      Comment

      Previous template Next
      Working...
      X