what do you feel the best way to route vacuum hoses for MAP based standalone is?
for example.
i have three things in the dash that need a vac signal:
megasquirt
analog boost gauge
electronic boost controller
right now there is a T going between the gauge and MS, the EBC isnt installed yet. i do get a bit of map signal noise. mostly when i am in boost. i'm considering:
a vacuum log, fed by one large hose, then split off to all three things.
two hoses from the engine, one for the MS, one for the other two things
-or- one hose for the gauge and one split between the MS and EBC
for example.
i have three things in the dash that need a vac signal:
megasquirt
analog boost gauge
electronic boost controller
right now there is a T going between the gauge and MS, the EBC isnt installed yet. i do get a bit of map signal noise. mostly when i am in boost. i'm considering:
a vacuum log, fed by one large hose, then split off to all three things.
two hoses from the engine, one for the MS, one for the other two things
-or- one hose for the gauge and one split between the MS and EBC
Comment