BP Ramhorn, B6T rods, + B6T parts

[ryan1]

BP ramhorn turbo manifold for a t3, was from ebay a few years back, it was made for a miata so i bought
it and cut the flange off and flipped and add a 3/8 steel brace between headflange and turbo flange for
extra bracing and to prevent cracking, i pulled it off a year or so ago from my escort gt and put header
wrap on it, dei black wrap with ss ties to hold the wrap down. then later on desided to go a different route
with the escort gt.
150.00 shipped.

ALL B6T PARTS ARE FROM A 88 MAZDA GTX, that just had the motor rebuild with je pistons and was went
thru so they are super clean, i bought the car and never drove it, as some stuff was missing and unhooked
and im finally finshing up a total resto on the car, i mean complete resto, it now has a bp with boost,megasquirt
and will be getting a toyota gt4 tranz and rear diff,ect swap probably this winter.

stock vj-14 downpipe/cast elbow 35.00 shipped
stock block B6T block 75+ shipping
stock B6T exh. manifold 70.00 shipped
stock B6T intake manifold 35.00 shipped
stock B6T rods 150 shipped
stock B6T injector with fuel rail and harness 40.00 shipped
stock B6T plastic tubes, uppipe from turbo to vam and t.b. to i.c. 35.00 shipped for both
stock B6T T.B. with tps 35.00 shipped
stock B6T IAC and homemade vam to 3 inch air filter adapter made by P.O.offer me a price

[FE3-323]

you have a PM

[ryan1]

pm replyed

[Ace]

I want that manifold. too bad it would be stupid for me to spend money on that kind of thing now.

[yunvmyegt]

pics of the manifold on the car by chance? if ryan didnt snake it already...

[ryan1]

pics of the manifold on the car by chance? if ryan didnt snake it already...

im not sure if i have any, i will have to check

[ryan1]

intake manifold sold

[ryan1]

rods are pending, bpt323 might take the manifold, but is still unsure at the moment.

[ryan1]

stuff is still here.

[ryan1]

anyone interested?

[mx-3_4evr]

PM'd

[BTR-GT94]

will the manni clear a stock rad?

[ryan1]

will the manni clear a stock rad?

i dont think so, i ran a griffen chevy V8 rad , but i have ran civic dual core 1/2 sized ones on my other boosted bp cars with no problem.

[BTR-GT94]

i dont think so, i ran a griffen chevy V8 rad , but i have ran civic dual core 1/2 sized ones on my other boosted bp cars with no problem.

damn....i'd pick this up from ya if it would clear....

[ryan1]

damn....i'd pick this up from ya if it would clear....

swapping in a 1/2 sized civic rad is not that bad of a job to do, then you will have alot of room for turbo stuff.