AL4SPN - Evo Drivelined Gtae

[nerd racing]

nice time!

[Iantboyd]

Incredible build. Maybe I missed it but what turbo are you running? Love the mani any chance of having another built? I would love to get my hands on a nice twinscroll, twingated manifold.

[323GTX-RSA]

Awesome build.

[NoBoDy_nz]

Incredible build. Maybe I missed it but what turbo are you running? Love the mani any chance of having another built? I would love to get my hands on a nice twinscroll, twingated manifold.

I am running a turbonetics GTK 450 at the moment, manifold is easy, sadly i am living in the uk at the moment and car is in storage so i cant really help any good performance shop should be able to make you one

[tweety2300]

Any way you could post some detailed pics of how you mounted the trans? I've been stuck on the cross member part of doing an entire evo swap

Also did you use custom axles and drive shaft or did you find some that would work

[NoBoDy_nz]

Any way you could post some detailed pics of how you mounted the trans? I've been stuck on the cross member part of doing an entire evo swap

Also did you use custom axles and drive shaft or did you find some that would work

There a photos on the first page, mounting is very simple, i have a custom chromoly crossmember and custom top engine and gearbox mounts, axles are custom drag spec as well using evo inner cvs and toyota outers to make sure it stays reliable, driveshaft is custom as well using evo ends and mazda hanger bearing in the center :D

[tweety2300]

Not sure how I misse that one, thanks itl help me out an save me a lot of time

[tweety2300]

I read the whole threa this time to make sure it wasn't covered but what did you do for the shifter linkage?

[nerd racing]

^^ my guess is EVO shifter and cables.

[NoBoDy_nz]

I read the whole threa this time to make sure it wasn't covered but what did you do for the shifter linkage?

Yep Evo shifter and ables mounted in the standard place

[NoBoDy_nz]

Wow, havent updated this in a while!

Cars now running full gtr hubs, with gtr rear brakes and my wilwood setup up front, have BBS LM's for street driving and Evo 4 wheels for drag racing at the moment,
Still havent gone faster than 11.3 but have some intake temp issues that i am trying to sort then I might finally get that 10sec pass.

Also had a the gtae graphics reproduced down the side not 100% but pretty good

[FamiliaGT]

Where was I for this????? Sadly all the photos don't work.
Looks impressive though!

[NoBoDy_nz]

Did a few little things on the mazda over the weekend, on the quest for a bonnet I found this at zebra

Finally have white heater controls

From this

To this


Also wrapped my down pipe in titanium lava wrap, seems to have brought the under bonnet temps down a bit, also swapped my cam cover out for another one as mine had cracked around my intake stays.

[Mr N4SA]

This is one the best BF323s out there. Great to see its still going and receiving attention.

[NoBoDy_nz]

This is one the best BF323s out there. Great to see its still going and receiving attention.

Cheers :D

Have been doing some more work on her
Upgraded the intercooler to a HDi GT2 600x300x80mm one as the old one just wasnt big enough for the power level,