Well it has been 20 months that i have started to build my Stroker 2.2 Mazda FE Dohc motor, where do i start
Well i will start with the crank and the block, as we all know that there are oil issues with the crank, spinning bearings, well i have done quiet a bit of mods on the Block and the Crank, what i did on the Crank is that i have crossed drilled the mains and the rods, here is a picture of the cross drilling that was done.
Here is a picture of the crank that i have polished a little bit
There has been quiet a lot of mods done onto the Motor Block its self, to over come the oil issues, i also have o-ring the block to boost, here is a picture of the Block
It has taken me 10 months alone to finish the Block, as we all know how long the engineering companies take, i forgot to mod the crank for the fe oil pump, just wanting for that, then i will ass the block.
Well i will start with the crank and the block, as we all know that there are oil issues with the crank, spinning bearings, well i have done quiet a bit of mods on the Block and the Crank, what i did on the Crank is that i have crossed drilled the mains and the rods, here is a picture of the cross drilling that was done.
Here is a picture of the crank that i have polished a little bit
There has been quiet a lot of mods done onto the Motor Block its self, to over come the oil issues, i also have o-ring the block to boost, here is a picture of the Block
It has taken me 10 months alone to finish the Block, as we all know how long the engineering companies take, i forgot to mod the crank for the fe oil pump, just wanting for that, then i will ass the block.
Comment