Official 2014 whatever thread

[KAinjection]

If anybody needs to sharpen a knife, this stuff works amazing:

http://www.toolsforworkingwood.com/store/item/ST-MAF.XX/3M_Micro_Abrasive_Film__for_Scary_Sharpening_-_PSA

Also going to pick up an 88 MX-6 GT parts car this weekend.

[FE3-323]

^ want to sharpen my knives for me??? seriously they can't hardly cut an orange peel :/

[DuRWooD]

I sharpen knives for all my buddies. I use a Spyderco tri angle sharpmaker. I could shave with my kitchen knives if I were so inclined.

[KAinjection]

^ want to sharpen my knives for me??? seriously they can't hardly cut an orange peel :/

Haha, well I am no professional and the sharpener that comes with most kitchen knives is useless to me, but as long as you have a steady hand and some patience those sheets will get knives to the point of being like razors. I did try to sharpen the kitchen knives for my wife, and while it did work it's harder to do with a double edged blade and it doesn't last long since they are usually a stainless blade. I did buy a special high carbon steel Japanese professional kitchen knife with a single edge and it's much easier to sharpen and stays that way for far longer but you have to wipe it off immediately after getting water on it and it must be oiled when stored to avoid rust. It will cut meat like butter though.

I sharpen knives for all my buddies. I use a Spyderco tri angle sharpmaker. I could shave with my kitchen knives if I were so inclined.

I don't want my kitchen knives to be that sharp since my wife has cut herself a few times and if they were that sharp i would have to take her to emergency room instead just giving her a band-aid. There was one machine I saw before that you could cut those abrasive sheets into strips and use them in the machine but I can't remember what machine it was.

[riverrunnernky]

Internet Sighting-Craigs List

http://winstonsalem.craigslist.org/pts/4606722186.html




Hello ALL!!

Saw this ad and want to share it here.

Play safe!

[FE3-323]

HOLY ****!^^ that sir is an epic library
please repost that in the internet sightings on here

[irishkev90]

Of course no BH reading material. Booooo

[KAinjection]

The Millenia S is a complex car to work on, but still easier than anything German.

The supercharger is actually easier to remove than replacing all 6 spark plugs.

[CODY004WD]

I bought a new toy.

[atomicEGT]

You, my friend, have a problem.

[KaleoXtreme]

The Millenia S is a complex car to work on, but still easier than anything German.

The supercharger is actually easier to remove than replacing all 6 spark plugs.

What year millenia? Is it yours? I'm dreading the tune up I need to do on my 02 millenia S. Also need to replace vac lines/tees. Yay me, lol. I think then I'll be motivated to put the Ksports/rims/HID lights I have waiting to go on.

[KAinjection]

Yep it's mine, it's a 2001 that I picked up with a bad supercharger. I was going to fix it for my mother in law to drive but i am second guessing that idea now. It's a nice car but all the hoses/vacuum lines and solenoids everywhere is too much.

In case you didn't know, make sure those 2 small hoses that run to the supercharger are clean and clear and also the 2 ports going into the supercharger are clean and clear, otherwise it will start sucking oil into the rotor housings.

[KaleoXtreme]

If you're talking about the two vac hoses with the one-way valves built in, I checked those. I'm not sure what ports you mean?

[KAinjection]

These 2 ports on the supercharger:

[atomicEGT]

got my elbow tattooed today

aaaaaaaaaaaaaaaaaugh