flexible GTR turbo oil feed pipe

[Chrisgtx]

Hi
I've tried a search but had no luck,anyone know what size the oil feed pipe fittings are from the block (10mm?) to the turbo?,i want to buy a flexible feed to make life easier and was wondering if its the same as any other car?.

[93EGTT]

There is a Dorman HELP! banjo bolt for a GM you can use.

http://www.wihandyman.com/forum/showthread.php?37253-Oil-feed-line-banjo-bolt-alternative

The bolt description says 10MM. Ive read somewhere that something is 1/8 BSP, I think thats the turbo feed?
I'm getting a banjo bolt, banjo loop end with -4an fitting to a SS line to the turbo through the restrictor on the top of my VJ20.

[Chrisgtx]

Thanks,I have the bolt(which I did get from a brake caliper and re drilled) the solid hose is a pain when I want to remove the turbo,a flexi will be a lot easier.

[Iantboyd]

Theres a flexible line for this all made up on ebay. Ill see if I can find the link.

[Iantboyd]

Check out this item I found on eBay: http://pages.ebay.com/motors/link/?n...d=151277010254

[Chrisgtx]

Thanks for that,but,i need a banjo connection to the block,i run a GTR turbo and its really tight where it comes out of the block so the pipe will have to run flush up the block then out,pretty much following the original solid pipe route. it needs to be 45cms long,i'll probably end up getting the fittings and making one up.

[Iantboyd]

Pretty sure thats the same line im using for my gtr setup.

[93EGTT]

http://www.ebay.com/itm/10mm-x-1-25-to-4AN-Water-Banjo-Bolt-Fitting-Kit-Turbo-/161251857517?pt=Motors_Car_Truck_Parts_Accessories&hash=item258b5c146d&vxp=mtr

Or

[Chrisgtx]

that e bay one looks good,then its just a case of getting a 45cm length pipe with 4an fittings either end.

[93EGTT]

I've been having trouble finding a 12" braided line with 2 -4an fittings crimped on. Let me know what you end up doing

[jay92gt]

Check out this item I found on eBay: http://pages.ebay.com/motors/link/?n...d=151277010254

I am going to be running a gtr set up and the oil feed line was damaged so I bit the bullet and bought one of these. One end is angled and looks like it should clear I will get out to the garage this weekend and mock it up and post a pic to see if it works if not oh well it was only $30.

[93EGTT]

Does it thread into the turbo and the block out of the box? Will the restrictor orifice work for a VJ20 bearing type?

[jay92gt]

I will let you know as soon as I get a chance. Maybe this saturday.