Announcement

Collapse
No announcement yet.

GTX#1 has been under the knife and in for a new look

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    #16
    No write up. but here you go. 1 MX6 sunshade , carefully pull back the fabric on the sides, trim off some metal on each side to fit the EGT slider, Gorilla glue the fabric back in place the reinsert to EGT slider. I did this to both of the GTX's. A nice touch for sure. EGT sunroof is a bolt in. Just swap the rear mounting brackets to the BF pieces. Thanks and thanks.

    Comment


      #17
      what year mx6 by chance??
      ---Has ClubProtege helped you in someway? show your support by Contributing--- Click Here---

      1992- project FE3..... 313 WHP @ 9.3psi




      I pet my dash when I get into the car..."good car"
      he actually has a mazda tree, parts grow on it

      Comment


        #18
        88-91 iirc

        Comment


          #19
          Stunning car...wow!

          Comment


            #20
            Have any issues with sourcing new parts - trim, mouldings, badges, etc.?

            Comment


              #21
              I just replaced the hatch and door weatherstrips with new. As for trim stuff's I have all of that. You can still buy the badges from Mazda if needed. But yes it is getting to the point that most parts are going nla. Next is to replace the dash pad and stuff the coilovers underneath. I don't think I will put the side molding back on. That will depend on if I put the side skirts on or not.
              Last edited by azgtx; 05-09-2015, 08:32 AM.

              Comment


                #22
                Thanks Yasin.

                Comment


                  #23
                  Awesome.

                  Comment


                    #24
                    Beautiful build. The louvers is a nice touch to it. Thanks for sharing


                    '88 GT
                    '88 GTX
                    '85 Toyota Cressida 5-Speed
                    '88 323 GT
                    '88 323 GTX

                    Comment


                      #25
                      been squaring up the interior


                      Comment


                        #26
                        Looks so clean. Very jealous

                        Comment


                          #27
                          Whoa … looks newer than mine!


                          '88 GT
                          '88 GTX
                          '85 Toyota Cressida 5-Speed
                          '88 323 GT
                          '88 323 GTX

                          Comment


                            #28
                            Lovely!

                            Comment


                              #29
                              i love the older interiors!!!
                              ---Has ClubProtege helped you in someway? show your support by Contributing--- Click Here---

                              1992- project FE3..... 313 WHP @ 9.3psi




                              I pet my dash when I get into the car..."good car"
                              he actually has a mazda tree, parts grow on it

                              Comment


                                #30
                                Thanks. When and if this gets done again it will need to be completely redone..leather or something. The closest I can find to the oem fabric is a Bride fade but with BRIDE woven in every 6 inches..not to my liking. Bride was the oem supplier for these seats. Real tough anymore to keep these cars original. Get them fixed and throw them in a time capsule. Here is a pic or 2 of the interior in GTX #2 that I shot for the Hagerty policy.

                                Comment

                                Working...
                                X