To all K-Sport owners

[atomicEGT]

Any benefit to using these on a mostly stock daily?

[KAinjection]

Maybe a little bit like the say swapping from steelies to aluminum rims on the front wheels only, other than that not much I am afraid unless maybe the slight resale value compared to normal brakes.

This will mostly be for the nerds here who want to A: shave rotating/unsprung weight B:The racer/autoX C: Have done everything else and its a cool new part for this old car so I want it.

[FE3-323]

A & C its basically the same principle as taking weight off the rims. nothing bad can really come from it. id be ecstatic if i could shave ~2lb a corner

[concealer404]

Any benefit to using these on a mostly stock daily?

Gas mileage, bruh.

[jaxongtx]

What is the progress on the DIY coilover kits? Am I able to order yet?

[jaxongtx]

I'd be looking for BG GTR lower mounts with BF GTX uppers... I have a set of Koni 8610's ready to go. Also, is there a choice of spring length and rate for the ksport springs?

[concealer404]

What is the progress on the DIY coilover kits? Am I able to order yet?

Read the thread. Put on hold due to initial supplier backing out.

I texted him another possibility this morning, though.

[jaxongtx]

Oh my bad, I must have skipped over that when I got reading about the hubs and rotor hats!

[KAinjection]

Yeah I am still planning to get the Koni retrofit sleeves done, but I am working on the rotor hats at the moment.

[jaxongtx]

OK, are you planning on getting 5x114.3 hats or just the 4x100 at this point?

[KAinjection]

4 x 100 to fit OEM 10.2" brakes with oem calipers first.

There are very few people that have expressed interest in 5 lug and then they all want to run different size rotors.

[jaxongtx]

And I'm in for the sleeves when you get to them.

[KAinjection]

Progress

[FE3-323]

that looks awesome! did you send that image to me via email? i could only open the 2 .pdf files. i don't even know what the other file extensions were

[KAinjection]

Yes I think I sent that image and the PDF dimensional drawings. The guy finished both of them already and I should have them both 3D printed by next week for test fitting.