Hi guys,
I've recently bought a little '88 323 GT, non-turbo, just FWD with the OHC EFI B6. Intending to use it as a track hack, but found that the chassis mount for the lower control arm had decided to snap while I was driving it around.
A quick look at the FSM indicates it's not attached to any subframe, can anyone confirm that this mount is directly fixed to the body/chassis frame? I'll weld it back on if so, but if I can replace an entire subframe that'd no doubt be an easier option.
Ideally this picture will imbed into the thread
Cheers!
I've recently bought a little '88 323 GT, non-turbo, just FWD with the OHC EFI B6. Intending to use it as a track hack, but found that the chassis mount for the lower control arm had decided to snap while I was driving it around.
A quick look at the FSM indicates it's not attached to any subframe, can anyone confirm that this mount is directly fixed to the body/chassis frame? I'll weld it back on if so, but if I can replace an entire subframe that'd no doubt be an easier option.
Ideally this picture will imbed into the thread
Cheers!
Comment