Announcement

Collapse
No announcement yet.

1988 323 GT snapped lower control arm mount

Collapse
X
 
  • Filter
  • Time
  • Show
Clear All
new posts

    1988 323 GT snapped lower control arm mount

    Hi guys,

    Posted this in the newbie section (primarily because the forum told me to make my first post there), but I figure I'll have more knowledge in the BF specialist crowd.

    Anyway, I've recently bought a little '88 323 GT, non-turbo, just FWD with the OHC EFI B6. Intending to use it as a track hack, but found that the chassis mount for the lower control arm had decided to snap while I was driving it around.

    A quick look at the FSM indicates it's not attached to any subframe, can anyone confirm that this mount is directly fixed to the body/chassis frame? I'll weld it back on if so, but if I can replace an entire subframe that'd no doubt be an easier option.



    Cheers!

    #2
    Ouch..how did that happen?

    I have a GT and have to look under my car to see how it attaches...judging from all that leaking oil looks like you need to address some seals too.
    Last edited by slownrusty; 08-09-2017, 11:08 PM.

    Comment


      #3
      And that is not a good place for a break at all.

      Comment

      Working...
      X