Hi guys,
Posted this in the newbie section (primarily because the forum told me to make my first post there), but I figure I'll have more knowledge in the BF specialist crowd.
Anyway, I've recently bought a little '88 323 GT, non-turbo, just FWD with the OHC EFI B6. Intending to use it as a track hack, but found that the chassis mount for the lower control arm had decided to snap while I was driving it around.
A quick look at the FSM indicates it's not attached to any subframe, can anyone confirm that this mount is directly fixed to the body/chassis frame? I'll weld it back on if so, but if I can replace an entire subframe that'd no doubt be an easier option.
Cheers!
Posted this in the newbie section (primarily because the forum told me to make my first post there), but I figure I'll have more knowledge in the BF specialist crowd.
Anyway, I've recently bought a little '88 323 GT, non-turbo, just FWD with the OHC EFI B6. Intending to use it as a track hack, but found that the chassis mount for the lower control arm had decided to snap while I was driving it around.
A quick look at the FSM indicates it's not attached to any subframe, can anyone confirm that this mount is directly fixed to the body/chassis frame? I'll weld it back on if so, but if I can replace an entire subframe that'd no doubt be an easier option.
Cheers!
Comment