Boosted Escort Holset build

[MazdaNoob]

depends on what your base idle is set to i guess ..

[Boosted Escort]

I'd guess it was probably a vacuum leak that caused my problems with the iac delete as I had to fix a few. I may try out my block off plate again.

[jinx]

Here's what mine looks like and I even used the original gasket too.

[Mazda_Powered]

I just plugged mine lol

[Boosted Escort]

painted my traction bars gloss black

[FE3-323]

put em on already!!

[Boosted Escort]

https://www.dropbox.com/sc/fhnmp882tgt9gnx/cR_4aoMKsO

https://www.dropbox.com/sc/lwdbaw7h38tg5kv/mu-y9GwsDf

tried to install traction bars but ran into problems. Looks like ill have to cut that off.

[Boosted Escort]

put em on already!!

Ryan you'll be happy to know that I got them on today. took longer than I expected to install. still need to go for a test drive and make sure the bars are adjusted right.

[FE3-323]

Adjust the bars to neutral on both sides- with the car on the ground. Then adjust each side equal amounts pulling the arms to the core support.

did you just hammer up that ridge?? sorry about that. & whats with the picture & the gap? did you get that closed up? or were you jsut showing clearance to the IC piping??

[Boosted Escort]

I had to take a grinder to the ridge. even after getting that ridge cut off there was still a slight gap. Took it out for a test drive and man it handles like its on rails. punched it coming out of a s curve and got it up to 75mph. normally 55-60 is Max speed you want to take it at. and of course they also help with wheel hop.

[FE3-323]

glad your happy with the end result!