If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Wasn't talking about the manifold.oops. I mean wrapping all the hoses in the sheathing u see in the oil return for example and putting separators. My bad.
Alright. Wiring attack mode. I took everything off the old stuff and marked everything I'll need from it. Also had to dismantle my old dash board harness. I'm not going to wire any outputs like water pump relay until the whole thing powers up properly.
If anyone need spare ecu connectors or engine harness connectors hit me up.
Note to self - make sure to use a block twice the thickness of the header flange you are going to weld. Planning anything by hand sucks and takes way too much time.
Comment