projectors help...(gro harlem need advice)

[mazdatuner]

so im doing the how to on gro harlems site projectmazda.com the projector headlights ...first of all I am tottaly aware of all risk of damage to me or my car and or inability to pass inspection but ima still do it....I need some help on the wiring could anyone post some pics or advice gro's site is great but some of the pics are hard to make out i have em mounted perfectly and have all items to hook em up just dont want to start cutting wires before im absolutly sure what to do could anyone help me plz.... SPECIFICALLY WHERE IS THE RED WHITE AND RED W/ YELLOW RELAY?

[mazdatuner]

well got em on and wired wasent too hard tomarrow im going to get some washers and adjust em so they sit flush and arent all crooked and what not ..not to shabby though.....thanks to projectmazda.com

[VelBurg]

Yeah, I did the mod as well. I like it but I want to get the corners to sit flush. I dont have pics of it yet.. I though about heating the corner lamp with a heat gun to soften the plastic and maybe it can bend so it can sit almost flush with the light. What i used to make the lights sit tight inside was. instead of using all those washers. I used a total of 3 washer and 3 bolts. I place a washer and bolt on each opposite side of the metal where it get scewed throught so you can adjust how far in and out you want the light to come out and one nut and washer on the opposite sise of the plastics so it can break the tab off.. Its nice and tight once you get your lights adjusted for the grill to fit. Did you figure out how to run your low and high beams at the same time?????? I finally figured what I did wrong....If you need any help let me know...

[D323]

congrats on the install d00d.

[323Foreword]

Nice job

I also have halo projectors, but on a 323. I've had them for two and have years now. There still going strong.

Getting the corners to fit is the tricking part.

I grinded the sides of the lights and the corners. Also added a third screw on the corner.

Picture of my 323

[VelBurg]

where did you put the screw at exactly? I have a big gap on mine.. And no matter what I do I can do anything to close the gap closer.

[worldhazard]

323foreward... that looks awesome, it looks like u grindeddown both side a little bit, the outside look great, getting that all flush.. nice... did u get the inside down as well to get the grill flush aswell.

[protégébob]

Picture of my 323

Everytime I see your ride I wanna switch over to the '94 style hood/grille on my pro just for I can do those lights.

Mazdatuner, Looking good bro, remember if you start grinding to take off just a lil at a time, you can always take off more, but you can't add it back.

[323Foreword]

where did you put the screw at exactly? I have a big gap on mine.. And no matter what I do I can do anything to close the gap closer.

You can put the screw like mine, by removing the amber lense or from under the corner.