Ive spent 3 hours, 1 1/2 cans of liquid wrench and other various rust sprays (let set overnight) and a whole lotta swear words but the rotor will not come off.
Both sides (driver&p/side) are siezed to the hub.
Im basicaly looking for suggestions/past experiences with such a problem before I start with the largest hammer I have and possibly destroy the damn thing for the satisfaction.
I need to get them turned, but if I end up beating them into submission Ill just get some new ones, but they gotta come off 1st.
Yes, Ive taken the caliper off in case anyone felt they may need to ask.
Ive tryed;
large flathead and prybar, propane torch,(light heat away from the center near bearing, mostly around outside of rotor hat), size 12 1/2 with hard kick, everything.
Thanks guys..
Both sides (driver&p/side) are siezed to the hub.
Im basicaly looking for suggestions/past experiences with such a problem before I start with the largest hammer I have and possibly destroy the damn thing for the satisfaction.
I need to get them turned, but if I end up beating them into submission Ill just get some new ones, but they gotta come off 1st.
Yes, Ive taken the caliper off in case anyone felt they may need to ask.
Ive tryed;
large flathead and prybar, propane torch,(light heat away from the center near bearing, mostly around outside of rotor hat), size 12 1/2 with hard kick, everything.
Thanks guys..
Comment