normal light driving should not cause it to get glowing hot. whats your timing like? & AFR's?
what size dump is on that again?
what size dump is on that again?
-
---Has ClubProtege helped you in someway? show your support by Contributing--- Click Here---
1992- project FE3..... 313 WHP @ 9.3psi
I pet my dash when I get into the car..."good car"he actually has a mazda tree, parts grow on it
-
Cleaned the AEM filter on the bg for what's probably the first time since I've been on island, so ~2 years.
Was getting oil sheen on the cleaning water through 5 buckets of water not to mention how bad the soapy water bucket looked after the 15min soak.
Wouldn't be surprised if i see a bit of a MPG bump.
Still need to replace injector o-rings and O2 sensor before I see anything of merit though.
Also clutch is dying after 80k.Beater=/= Sleeper
Originally posted by kozzman555Using Linux for anything serious besides server or software dev is like using a tin can and a string for telecommunications.Originally posted by HopelessCowComment
-
what clutch?---Has ClubProtege helped you in someway? show your support by Contributing--- Click Here---
1992- project FE3..... 313 WHP @ 9.3psi
I pet my dash when I get into the car..."good car"he actually has a mazda tree, parts grow on it
Comment
-
It's all stock GT-X stuff. Timing is set according to the FSM except as changed by the shaving of the head. The only non-stock parts on it are the FMIC and piping and BOV. And now the wideband, of course. It stays pretty close to 14.7 at light load and idle, drops to about 12 at WOT, and pegs lean on overrun.Originally posted by FE3-323 View Post
The glowing seems to be reduced with the new o2 sensor, but I still see it faintly sometimes. I think need to check my intake for leaks that only occur under boost. And I need to get new injector o-rings just to be safe.1990 Protege 4WD
GT-X BP26 swap [AT->MT]|Cup holder cut to fit|Synthetic gear oil|Synthetic brake fluid|Corksport SS brake/clutch lines|Mazdaspeed HV oil pump|GT-X front STB|Corksport type I rear STB|Matching full-size spare wheel|Homebrew Brass shifter bushing|Speed Source brass shifter cable bushings|EDM headlights/corners|FMIC|EDM cabin vents
1 3 5
├┼┤
2 4 R
Seeking: Canadian 4WD seatbelts.
Comment
-
yo, I just read that Canadian MX3s had heated seats? is that foreals?
I want to add heat to these jams, and if there's a factory way to do it that would be super rad.sigpic
03 Accord DX: K24/5MT, peasant-spec old man's car
92 240SX: KA/T25, nerd mobileComment
-
I think that is why the center consoles have the blank switch covers near the handbrake. At least mine has them.92 Mazda MX3 GS> For sale, $1750 OBO
94 Escort wagon--BP swap coming, VF10 Turbo, COP, EVO ECU, 03 ZX2 front end conversion
"Hold yourself accountable before you are held accountable"
EV14 330cc@3Bar injector kits available.
EV14 GT500 injector kits available for the BP. 610cc@3Bar.
EV14 925cc@3Bar injector kits available
BP Forged H beam rods available now
KL Forged H beam rods available now
K8/KF Forged H beam rods awaiting test fit
FS Forged H beam rods awaiting test fit
F2 Forged H beam rods awaiting test fit
FE3 Forged H beam rods coming soon
Mitsubishi 3.8 MIVEC rods coming soon
Aluminum CAS/Distributor caps
BP oil jet eliminators
EV14 fuel rail spacers
More stuff coming soon.......Comment
-
-
oh, yeah, that's right- I forgot that my MX3 had those blanks.
did regular seats have them or just the leather ones?sigpic
03 Accord DX: K24/5MT, peasant-spec old man's car
92 240SX: KA/T25, nerd mobileComment
-
or like I'm sure it just makes more sense to buy some of those aftermarket pad things and do it that waysigpic
03 Accord DX: K24/5MT, peasant-spec old man's car
92 240SX: KA/T25, nerd mobileComment
-
-
dangarang. maybe I'll just buy the kits then. any of you dudes ever added heating elements to their seats?sigpic
03 Accord DX: K24/5MT, peasant-spec old man's car
92 240SX: KA/T25, nerd mobileComment
-
ACT 6 puck.Originally posted by FE3-323 View Post
It's lived a hard life, and I ride it a lot more than I should to ease engagement.
I picked up a exedy full disc kit because the 5mph stop and go traffic here just kills my leg.Beater=/= Sleeper
Originally posted by kozzman555Using Linux for anything serious besides server or software dev is like using a tin can and a string for telecommunications.Originally posted by HopelessCowComment
-
I haven't, but a friend from my school did it, and he said it was pretty simple. He got his from here: http://www.heatedseatkits.com/index.htmlOriginally posted by atomicEGT View PostMy family has lots of bg's!
2003 Ford Escort ZX2: Project car/future daily driver. Built Ford Tough (With Mazda Stuff)
1999 Escort ZX2: Daily driver/beater. Going to be replaced by the '03 next summer.
2000 Escort ZX2 S/R: bought wrecked, going to use as parts car
1992 Protege LX: My old race car. Just a wrecked shell right now. Waiting for scrap to go up so that I can get rid of it.
1992 Mazda 323: Race car
1992 Escort Gt: My grandpa's old race car
1994 Escort GT: My grandpa's new race car.
Parts cars; 1993 Escort Gt, 1995 Escort lxComment
-
Painted and hooked up to a spare escort gt foglight I found.
sigpicWorlds first car with GPS was a Mazda
~~~~~~~~>
Thanks again to member gooseinyou for the familia garnish <~~~~~~~~Comment
-
^ sigh. i miss mine. can't wait till i get it put in next year.---Has ClubProtege helped you in someway? show your support by Contributing--- Click Here---
1992- project FE3..... 313 WHP @ 9.3psi
I pet my dash when I get into the car..."good car"he actually has a mazda tree, parts grow on it
Comment
Comment