mx3 rotors vs 323 rotors

[illicitq]

different right??? are the front spindles different too?

[323driver]

yes and yes

[illicitq]

thanx! okay so.. im swapping my bpt from my mx-3 to my 323.. i was lazy to break the axle hub nut ( and lacked the proper equipment) so i removed the spindle and are swapping those too.. so will there be any problems with the mx-3 using the 323 spindles and brake components?

[Mazda_Powered]

best bet is to swap everything over from the mx3 to your 323. i'm talking about front and rear subframes with the swaybars. 323s don't come with a front bar and mx3 lower control arms and rear link arms tend to be a bit longer thus giving you more width.

also the mx3 exhaust will bolt up to the 323 perfectly and are the same length.

JACK.

[illicitq]

oh yea i was thinking that but i plan on selling the mx3 to a friend cause he needs a car to get around.. so i dont want the mx3 to be unsafe for any reason.. if that wasnt the case, believe me everything would have been swapped over like yesterday.

[Kitty]

well you would be putting under rated brakes on the mx3. Besides that it'd be fine.