Universal Rear (or front) Pillowball mounts

[JPmotorsports]

I stumbled onto these things for a rallycar project and became a distributor. They are truly universal---they don't even have holes drilled in them, and you can get the bearing above the plate, below the plate and even offset. They're 1/4" steel so they could even be welded right to the top of the strut tower if needed---this would solve the problem of bottoming out a stock strut/or strut insert (ie KONI red) raising the hole unit up 2" allowing the car to be lower without sacrificing travel---they're cheap---about $150 a pair...

[mx-3_4evr]

Damn! Those are cheap! How mutch extra would you charge to make it a bolt on into our cars?

[concealer404]

^What he said! I'd be interested in a pair already set up for the rear.

Or if i could send you some MX6 stock mounts, maybe a 4-corner set for that car? :D

[JPmotorsports]

Damn! Those are cheap! How mutch extra would you charge to make it a bolt on into our cars?

^What he said! I'd be interested in a pair already set up for the rear.

Or if i could send you some MX6 stock mounts, maybe a 4-corner set for that car? :D

It's probably not cost effective to have me do them---probably take an hour plus a bit to do a set so like $100 labor or so. But I guy could cut them down in a vice or on a bandsaw/whatever at his house, line up and drill a couple holes, then get some spacers for what ever strut he wanted---if you get the offset one you could even flip it around to change camber!!

[SgtRauksauff]

ooh. aah. yeah......

[Mazda_Powered]

that's a nice find! I think ksport has fronts for the BG pretty cheap (around the same price) but these would be a great alternative for rear plates, since cusco is the only company @ around 260-280 for the set.

[jrally]

HotBits makes steel mono-ball plates for our cars, but I think they are about $150 a corner, I think.

-Jon R.

[Mazda_Powered]

they're in canada too (hot bits), might be interesting to see what they have....