If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Hey all. I just put a trany out of a 98 into my 95 (1.5) It shifts great but it makes that "grind" noise when I try to shift into 5th. I was told that the tranys would match up no prob. Any advice?
bad synchros?
you need to get it rebuilt or just get another.
or it could be fluid. have you tried royal purple or any high performance synthetics? sometimes that'll cure the problem.
Almost there
jdm tails... check
jdm bumper... check
ms lip... check
ms grill... check
ms sideskirts... check
ms rear skirts... check
ms spoiler... check
ms struts... check
Still trying for a bp swap..:
Fidanzda 8lb flywheel, ACT HD00, UR Crank Pulley, UR Adj. Cam-Gears, Exh-Intake CamShaft Swap, MS Engine Mounts, Custom CAI, PaceSetter Header, 2.25" in/out-let Magnaflow Cat, 2.25" Mandrel-Bent Exhaust.
Comment