What did you do to your BH/CBA Today?

[Beerizfood]

Mfactory diffs almost ready to ship soooooo......

I thought i should get my lazy azz out to the boneyard .
I spent 4 hours in the sun ripping the g-tranny and axles,spindles etc from the NEO.I grabbed all the motor mounts and starter as well.
The ole whip will going through some major changes soon with the 1.6 headswap with ITB,s and the tranny.Im lookin for a flywheel and clutch as well.

[3ni_tricksta]

sideskirts;

[firelizard]

OOOOOHHHH what are those?

too lazy to search I am

[Henchman]

Mazdaspeed Protege skirts right?

[Henchman]

I thought i should get my lazy azz out to the boneyard .
I spent 4 hours in the sun ripping the g-tranny and axles,spindles etc from the NEO.I grabbed all the motor mounts and starter as well.
The ole whip will going through some major changes soon with the 1.6 headswap with ITB,s and the tranny.Im lookin for a flywheel and clutch as well.

Beer!!! I could totally use the sway bar from that Neo, think you could snag it for me?

[Beerizfood]

Beer!!! I could totally use the sway bar from that Neo, think you could snag it for me?

Front or rear?

[Henchman]

Front

[Beerizfood]

Front

you still want it if its only the 19mm?

[Henchman]

It shouldn't be if it's an LS, but if it's only the 19mm, then no.

[Beerizfood]

It shouldn't be if it's an LS, but if it's only the 19mm, then no.

OK Ill check it out next trip there.

[3ni_tricksta]

Mazdaspeed Protege skirts right?

nah protege5;

[Eric]

nah protege5;

did they just fit right up 3ni?

[3ni_tricksta]

did they just fit right up 3ni?

some modification required; and a gap by the door sills that i gotta fill;and it was almost the right lenght

[Eric]

awesome, i figured that something would need to be adjusted. Did you buy it used or new? I am currently talking to Ground Dynamics about a pro5 02-03 kit,

[trippingonme]

Changed oil. When I got under the car, I noticed more rust than I would have like to see...

So anyways, off to the junkyard for some new mounting thingy for my exhaust pipe. Need to get under there and de-rust some things. This is something I've never done, any tips? Something I could easily (and cheaply) coat things with so I won't have to do it again next week?