GB: Passenger mount for E153 adapter plate group buy- SECOND CHANCE UNTIL MARCH 10TH

[neuspeedescort]

nice!


NEUMAN

[ftjandra]

Ready to ship out!

Ok, I gave the welded mounts a quick sand blast to clean up the weld beads and surface rust. I made the sleeves yesterday and so they are now ready to ship out.

For those that have already paid in full, I just need to know whether to ship them to Jon for powdercoating or to you. Scott/Hadoken, I don't have your address.

For those that still owe the remaining balance, please pay asap. I will not start the driver side mount until I have all these paid in full...



--Ferdi

[wheresthericego]

Please PM me my balance. I think I did the $35 down payment

[therieldeal]

slickkkkk

[Crazypunkerguy]

Paid In full, PM me when details are out for the drivers mount please I will want one of those as well!

[SPENONE]

I dont know how the **** i missed this....:sigh:

[ftjandra]

I dont know how the **** i missed this....:sigh:

I do have materials for one extra mount, but it does have a little cut on the edge from where the waterjet must have messed up or something.

Also, a few guys have contacted me/Jon about getting their mount zinc-plated. There is local place to me that can do it, but it would be $30each and I need at least 5 because the minimum charge is $150. If we do it soon (i.e. before the driver side mount is done), then I would only need 4 because I will do my adapter plate then.

--Ferdi

[ftjandra]

Ok, I have enough people wanting zinc-plating to meet the minimum charge. But, I will have to do them at the same time with the driver side mounts. So, even if you are not buying the driver side mount, you will have to wait to receive your zinc-plated passenger side until those are done. Also, I already asked, but the price stays the same at $30 per mount because the numbers are just too low.

I just realized that I forgot that the driver side is actually two pieces, so will most likely cost more to zinc plate.

--Ferdi

[ftjandra]

Ok, this group buy is officially closed as everybody has fully paid.

I'll be sending Jon's mount back tomorrow along with two mounts for powdercoating (wheresthericego and Hadoken).

In case you missed it, I made a separate thread for the driver side mount here.

--Ferdi

[therieldeal]

rec'd the two mounts for coating today - they look great!

still havent heard from the two guys getting the coating so... sending some PM's

[therieldeal]

the (2) mounts i received for powdercoating were done this morning

super high quality cell phone picture...

[ftjandra]

Some people have expressed interest in the passenger mount after the group buy closed. I can have some more cut when I get the driver side parts made, but it would be $15 more unless I get more than 3. So, here is your last chance to get one. The deadline is March 10th.

--Ferdi

[scortadict]

i'm in for the passenger mount if i can also get the driver mount.

[ftjandra]

i'm in for the passenger mount if i can also get the driver mount.

See the other thread for the driver side mount - it's not even in production yet and the deadline for deposits for it is March 10th.

Also, since you are in Canada, you will need to pay extra for shipping.

--Ferdi

[ftjandra]

Bump, only a few more days to get in on this as I doubt that there will be another groupbuy in the near future.

--Ferdi