WTB: Help me rebuild my car

[concealer404]

Well, i had a bunch of parts get stolen off my MX6. Soooo... i need to replace them.

Here's what i'm looking for:

1) Tial 38mm or 40mm wastegate
2) Any decent BOV. NO KNOCKOFFS
3) Intercooler. (2.5" or 3.0" inlet/outlet) Nothing huge, but i can't put a tiny dinky little bastard on this thing, either.
4) Piping, couplers, t-bar clamps, etc etc etc.


Let me know what you've got, and your price.

[Mazda_Powered]

i've got a 1st gen DSM by-pass valve that's been modified....i can include the flange. Should hold upwards of 25psi now.

not my pic, but its the center one for reference http://www.mx6.com/forums/1g-mx6-for...ypass-you.html

pm me if interested, not asking a lot.

[concealer404]

i've got a 1st gen DSM by-pass valve that's been modified....i can include the flange. Should hold upwards of 25psi now.

not my pic, but its the center one for reference http://www.mx6.com/forums/1g-mx6-for...ypass-you.html

pm me if interested, not asking a lot.

I appreciate the offer, but i'm going to pass on that. I'm not sure that it'll hold up to what i'll be doing to it by the end of summer. Thanks, though.

[concealer404]

Turbosmart 38mm Ultragate pending. Will update original post when/if it's in my hand.

[yunvmyegt]

theres a few tial's around here i might be able to grab....

[concealer404]

BOV or Wastegate? I've got a wastegate lined up now. Grabbing it at 3. I'll update when it's in my hands.

If it's one of their BOVs, i'm extremely interested. Always wanted to try one anyways.

[concealer404]

BUMP.

I have a Turbosmart Ultragate38 and an Evo 8 FMIC in my hand.

Need a BOV, piping, couplers, and t-bar clamps.

[silverton]

Curious, how did this happen??

[concealer404]

Curious, how did this happen??

Long story. The car has been parked at a "buddy's" place while i've been fighting to get the time to button it back up again. Went to go pick the car up Sunday to tow it to where i'll be working on it, didn't take a good look at it until i was dropped off. Popped the hood, all this crap was gone.

Can't do much about it since i can't nail down the exact date it was all stolen.

That's the long and short of it. I don't even care anymore. Just trying to get it running again.


Anyways:

Piping, couplers, and t-bar clamps taken care of.

Just need a BOV. Probably prefer a Greddy of some sort, since i can get a pipe that already has the flange on it, so no welding required. RS or Type S is fine.