Does anyone have a base tune for a bpt and is willing tote me use it??
Thx
Greg
Thx
Greg
-
-
what injectors, whats the set up, i have a few around92 protege lx-
94 protege lx-
95 escort gt-ms2e/ms2extra pre3.3alpha5 gslender v2.8-e85-vj23@12lbs----dead--
are you a thinker, or a believer? -
if your talking ms1 extra and a completely stock BPT engine i got a couple..
had a great one till yesterday when i forgot to save it b4 running the analyzer and it ****ed things up.. butComment
-
Stock engine with exhaust, intercooler and sequential...Comment
-
It's on a ms3 but I don't think it matters???!!Comment
-
the table sizes are diff and there are diff. between ms1 and 2 so im sure 3 is diff as well... what exactly are you looking for? spark/fuel tables?
josh helped me out with mine a while back he may have something a little closer to what you need then what i do.. I dont mind sending you a copy of my MSQ you can give it a shot but idk if it will transfer over correctly and all when you load it into TS..
give me your email and ill send you a copy of the MSQ im currently using its a bit rich over the whole map and the spark tables are hardly touched but she runs fine and is a good starting point..Comment
-
MS3 will take MS2 (assuming both are MSE) .vex tables everything else should be setup by hand"Discontent is the first necessity of progress."
-Thomas A. Edison
"There is a fine line between ballin' on a budget, and dreamin' on an empty wallet."
*Junked* 92 mx3, BP swap- milage whore, beaten up and down the east coast
*Junked* KLZE powered 323 on Megasquirt 1
172.60HP & 156.93 TQ with only headers and short ram intake. back under the knife for a BPT swap.
New Daily stock 1.6L 1999 Mazda Protege LXComment
-
I want the fuel and spark table.... And see what I can do for the cold start!!!Comment
-
im sending my msq my spark and fuel tables to ya now.. not sure if they will be compatible at alll so i take no responsibility if u fuk something up lol my **** runs fine like this but its with MS1..Comment
Comment