If this is your first visit, be sure to
check out the FAQ by clicking the
link above. You may have to register
before you can post: click the register link above to proceed. To start viewing messages,
select the forum that you want to visit from the selection below.
Im Looking To See How Everyone Has Set Up There Intercoolers On There BF 323's. So Post Up Any Pics Of Your Intercooler Setup's And How You Ran Your Pipe'n.
Also Add Your Upgrades!!
Thanks,
C Dot
'95 Ford Escort LX, GTX block .40 over, wiseco 9.1 pistons, gtr rods, gtx head, MS1, 550 inj. T3/T4 .57 Trim, DSM BOV, WALBRO 255 FP, civic half rad, MSP LSD, stage 3 kyclutch, ebay short shifter, mx-3 rear tie bar, AEM wideband....SHE IS ALIVE '88 Mazda Gtx AWD B6T engine Ported head, VJ-11, EL prototype chipped ECU, Blitz SBC-iD electronic boost controller, Full HKS exhaust, Centerforce dual friction clutch & more
Ive only got limited pics but ill take some more tomorrow? I just used a mitsi VR4 facory intercooler so i didnt have to chop the factory bumper up i couldnt bear to do it cause its so hard to get hold of another one.
Comment