need how to, for putting a bp engine in a bf 4x4

[trailrider098]

The Aussie site = fordlaser.com

You may not find the info you need here, the BF chassis section is relatively new in the CP world, many people here with bp swapped bf's have had it done for a while

[BFMRGTX]

and the yahoo site i searched when BFMRGTX mention the site, but diden find there either. ,&the auzzie site i not even heard off before now,
isent this the mening of having a forum to ask questions ?? .

The yahoo GTX forum is a bit difficult to navigate, but the information is there. You just need a little patience and some time to get used to the layout of the text-based system.

I have no problem finding the information, and I know you can find it too. I also know that you could ask the yahoo forum, and you have not done so.

[low and slow]

ok so now i have started the swap.

only thing i had to do to get the box on was tho chop a lilttle piece of the dust sheild around where the rigft axle goes in.

i used b5 flywheel but i used bp na clutch and presuer plate, pretty sure i could have used the bp na flywheel to.

but when i put the rigth side axel in, then the bolt that is bolted to the block is way off. how do you solve this problem.

and i did see in one tread that some one make a little notch in the frame rail to rom for the alternetor, is that realy needed to do that to get it to fit?

[BGfamiglia]

i've heard people talking about the yahoo gtx forum, i've had a hard time finding it, or maybe im just stupid, can anybody shine a little light on that for me?

[BFMRGTX]

http://autos.groups.yahoo.com/group/323gtx/messages