Installed some Hella Driving lights. Jeeze, these things is bright!
-
Mazda
1988 Black 323 GT
DOHC 16 VALVE TURBO
2013 Velocity Red Mica Mazdaspeed3 -
Got my car aligned and got a under carriage wash with grease and spray.Comment
-
Installed the Turbine Tech lower GTX brace!!!Comment
-
i think i replyed on yahoo, but how close is it to the ground on your car?Originally posted by gpd323 View Post"See that car, in the 80's that car was deadly." Random man to his son while passing the GTX in a parking lot
-88' Mazda 323 GTX, 1.8t, Modified Magazine May 2012Originally posted by neuspeedescort
-88' Mazda 323 GTX, caged and ready for dirt
-93' Mazda Miata, half caged
-09' Mercedes C63 AMG
-87' Toyota Land Cruiser, 33's with slight lift, safari style!Comment
-
As a height reference, my GTX at the front measuring from the ground to the front upper most fender lip is 23.5"Originally posted by trailrider098 View Post
So using that to see where my cars sits compared to others is necessary. The lower TT brace is 2.75 inches off the pavement. The RRE brace I had had forever, is 3 inches off the pavement.
That is very close to the ground for sure.Comment
-
I installed a Spec Stage 2 clutch and put the tranny back on. Also reworked some of the electrical connectors and tidied up the wiring...Comment
-
Dude! What took ya? :D
Im 323SE.Mazda
1988 Black 323 GT
DOHC 16 VALVE TURBO
2013 Velocity Red Mica Mazdaspeed3Comment
-
He took some convincing... ok... really he just had to log in.. the weasel.
1988 White GTX - #1 parts
1988 Black GTX - #2 reliably broken touge monstar (294,000 miles no rebuilds) - dead
1988 Blue GTX - #3 in progress (view here)
1988 Blue GTX - #4 BPT swapped weekend warrior.
1988 White GTX - #5 Rally carComment
-
Installed the new pedal assembly. I'd rather eat **** and live than do that again. On the plus-side: Clutch play is much better. The old clutch pedal, where the clevis pin goes through the lever, had an elongated hole so it made it impossible to shift. Just need to adjust the pedals and I'm good to go until I get the rear LSD and paint the bumpers.Comment
-
taped up the driver's side window to prevent more snow from getting it. Should've done that before we got a foot of it... hopefully it doesn't get warm and I can vacuum it up with the shopvac before it melts all over the seats.Comment
-
got the car ready for super cold temps. it's been like 2 degrees in the morning and not much warmer through the day and i get to drive my car for work so i want her comfortable in the cold too.Comment
-
Moved my oil pressure gauge from the center console to the 3 gauge pod holder on the A pillar.Comment
-
Paid good money to have an alarm system installed with two FOBs and power door unlock. Now my car feels more like it's from this decade!Comment
-
been cleaning the engine bay and got around to taking some pictures. i mean cleaning as in tidying up...a little. no full wire tuck or anything like that.Comment
-
Took apart the front of the engine to confirm the front main seal is leaking before ordering the parts. Lots of fun!
BobComment
Comment