GB: Toyota E153 -> BP adapter plates (CLOSED/awaiting delivery)

[scottx3]

yeah shafts and LSD and spare gears. not bad for $400 AUD. haha.

[scottx3]

OK everyone. do not buy an e58 levin lsd as it will not fit. they also have different gears in them.. so you can only essentially use the shafts



one on left is 4 spider camry diff and one on right is Levin viscous LSD.




so what LSD will fit? the 3SGTE MR2 one? and is there a difference between that and the 3SGE model?

[concealer404]

The MR2 LSD may fit, but it's not worth the hassle. It'd be cheaper and easier to just find an LSD MR2 tranny than it would be to grab a Camry/Solara E153 and then pay/or install yourself a 15 year old mediocre worn out factory LSD.

The LSD in the MR2 is nothing special. I would suggest a Camry/Solara tranny with an aftermarket LSD. There's a couple companies out there that make them, and they are reasonably priced.

[demzz23]

i need the adapter plate

i<m in for another GB

[scortadict]

i need the adapter plate

i<m in for another GB

i also need one, alrealy got the transmision and mount. therieldeal had 2 or 3 left, but its not online often.

[ftjandra]

I talked to Jon/therieldeal about a week ago and he still had three plates left at that time.

--Ferdi

[demzz23]

I send message to therieldeal
i dont receive answer

i order my adapter from corksport

[jesiotrot]

Corksport are selling adapter plates?

[scortadict]

I talked to Jon/therieldeal about a week ago and he still had three plates left at that time.

--Ferdi

next time you talk to him, can you let him know i still need one of the plate. i'm collecting part to do the conversion this winter.

[Wilyb]

Yup Yup

Yessiree bob,

I'm in on the next group buy...I'd buy an extra one right now but... again... I have to buy another winter beater...it won't be a Protege again though... I think 6 Pro's in the yard is enough...Then again, maybe I can swing it... Lemme know if there are extras lying around for sure...

[therieldeal]

yeah i still have three sitting under my desk at work, i'm just never on the internet anymore... and shipping internationally is a pain. the ones corksport has are not zinc plated.

[Mcwilly]

Hey I have recently done this conversion and having some issues. My clutch plates stripped the splines. So I have been told that my adaptor plate is possibly not aligned properly. I was curious if I could get some accurate measurements of the gearbox pattern and of the engine Bolt pattern to check my plate? I need the holes relative to a centre point to check the alignment.
Thanks chris

[Duste]

therieldeal, tried PM'ing you but your inbox is full - I'll take one of the extras if you still have one.

If you want you can post it to Jim @ Pierce Motorsport and I'll have it shipped over to Australia with my other gear.

[Racerboy]

therieldeal, tried PM'ing you but your inbox is full - I'll take one of the extras if you still have one.

If you want you can post it to Jim @ Pierce Motorsport and I'll have it shipped over to Australia with my other gear.

Therieldeal hasn't been on here for a long time. He won't be getting back to you.

[Duste]

No one has contact details?