DeeAOne's BF KLDE Swap.

[FE3-323]

you need a couple days, a soldering iron, solder, heat shrink tubing, a lighter, many rolls of E-tape

pull all the wiring & figure it out on a huge basement/garage floor pan

[DeeAOne]

i almost have the mx3 gs harness wired in, but something is still off somewhere. when i turn the key to the on/start position the fuse box has power but there is no power on the dash.

does this make sense to anyone?

[nerd racing]

you need to junction the GS harness' main thick blue wire in with both ends of your main power feed, instead of replacing it.

[Ace]

have you decided what you are going to do about the axles yet?

[FE3-323]

the main blue wire is primary power for the coil. not the dash. louis, please get me a snap shot of the plugs under the BF dash showing the wire colors

[Evilist]

i'll help you lol, on the BF harness side the main wires to connect stuff from the V6 loom is.

Black/White - This used to go to the coil you need to connect the the fat blue wire to it.(from coil) assuming its the same as the BH/A

so for your car it should be a face-lift model so 87 and up it uses a separate plug for the powering the ECU/FUEL components. Hopefully this is the same as JDM

Plug 1
*blue/red - ECU constant power
*green/red - fuel pump power 1
*green/red - fuel pump power 2 (same wire but theres 2)
blue/black - short connector at interior fuse box
white/green - stop light switch
black/blue - O/D switch

I'll take a pic of the black/white wire

[FE3-323]

^take pics of all your describing

[Evilist]

yup I'll take pics of them all tomorrow, its really dark atm lol so would be no point

[DeeAOne]

thanks for the help. this thick blue wire..i see it under the dash but not out under the hood.

have you decided what you are going to do about the axles yet?

i have a friend who is shortening a stock mx3 axle as we speak.

ill take some pictures of the wiring tomorrow. im tired and have school in the morning. bed time.

[DeeAOne]

just ordered this finally.

http://www.summitracing.com/parts/AFC-80105N/

here it is on Dan's car.



cant wait to fit it!

[DeeAOne]

24 hours later! lol





here is roughly how it will sit. its ziptied right now, but i will be welding some brackets on the frame for it. the rubber mallet was helping before the zipties. lol









with the front mostly on just to see how it looks. im loving it.



im unsure on what im going to have to do about radiator hoses though. probably going to have to run some type of hard line on the upper one. and the lower outlet on the radiator is bigger than the inlet to the engine. half an inch to be exact.

[nerd racing]

damn you and your space for a radiator still inside the radiator support... here is where my cam cover is in relation to the back of the outside of the support!

[DeeAOne]

damn you and your space for a radiator still inside the radiator support... here is where my cam cover is in relation to the back of the outside of the support!

yeaah i just saw in your thread. thats crazy close. lol

[Damkid]

^^Still more clearance then mine lol

[Mazda_Powered]

looking good man!!!