What did you do to your BG today?? - Part II

[Turpro]

How can there be rust on SS lines?

My thoughts exactly.

Eric your car amazes me everytime I look at it. Post up some pics of the underside of your trunk so I can put my spoiler on lol.

I never got around to the strut mount this weekend but it will most likely get done friday.

[Pox]

How can there be rust on SS lines?

[whistler]

finished my rear brakes today... but saw that there might be rust on my SS lines, need to get some pics...

[progt91]

did nothing and im not proud of it

[MazdaNoob]

right now i envy anyone with a garage .

[progt91]

I get a full alignment with custom camber settings to my liking. Then got my windows tinted with lifetime warranty 3M tint. Then on the way home I got some Hella 500 fog lights to replace the stock Bosch fog lights.

envious, walking space around car in garage lol

[jumpncrash]

love the tint, really dark

[deadly_sleeper]

I get a full alignment with custom camber settings to my liking. Then got my windows tinted with lifetime warranty 3M tint. Then on the way home I got some Hella 500 fog lights to replace the stock Bosch fog lights.

[progt91]

dude, build a kick ass motor with that thing. yeah man want to finish this damn car. its been too long sitting

[FE3-323]

fix u the ole pro!!

[progt91]

well i made some room in my garage today so i can work on the old beast tomorrow

[Clean 4WD]

Well I resealed one of the exhaust flanges today, hopefully get rid of one more exh leak.. And installed a new right outer front cv boot, and right side front axle seal at the trans.. Want to get all the leaks taken care of before this thing goes bye bye... tomorrow she gets a bath...

[Turpro]

Found out its not the exaust or strut thats fubar'd. Its the strut mount. rear pass side is shot. Hopefully I will replace it soon. It's annoying the **** out of me.

[diflictedminds]

will be orderingthem soon.

this morning I tried to pull out the other busted bolt from my engine member mount with a nother screw extractor. In doing so, I broke the extractor and had a wrench fly into my lip at 40 mph! So thankful it didnt happen to my eye. I also learned that there is a certain tool that your supposed to use instead of a crescent wrench when tightening a screw extractor into a freshly drilled hole!

[therieldeal]

just finished replacing clutch, axels, tie rod ends.... and realized that I shoulda replaced the input shaft seals....(totally see tranny fluid leaking from them!) Any suggestions:?

pop the axles out again and replace the seals